A 10-Gb/s Burst-Mode Clock-and-Data Recovery IC with Frequency-Adjusting Dual Gated VCOs

Yusuke OHTOMO  Masafumi NOGAWA  Kazuyoshi NISHIMURA  Shunji KIMURA  Tomoaki YOSHIDA  Tomoaki KAWAMURA  Minoru TOGASHI  Kiyomi KUMOZAKI  

IEICE TRANSACTIONS on Electronics   Vol.E91-C    No.6    pp.903-910
Publication Date: 2008/06/01
Online ISSN: 1745-1353
DOI: 10.1093/ietele/e91-c.6.903
Print ISSN: 0916-8516
Type of Manuscript: Special Section PAPER (Special Section on Analog Circuits and Related SoC Integration Technologies)
PON,  burst,  CDR,  IC,  CID,  

Full Text: PDF(1.5MB)>>
Buy this Article

A high-speed serial, 10-Gb/s, passive optical network (PON) is a good candidate for a future PON system. However, there are several issues to be solved in extending the physical speed to 10 Gb/s. The issues focused on here are not only the data rate, which is eight times higher than that of a conventional GE-PON, but also the instantaneous amplification and synchronization of AC-coupling burst-input data without a reset signal. An input amplifier with data-edge detection can both detect level-varying input due to AC-coupling and respond to the first bit of a burst packet. Another issue discussed here is tolerance to long consecutive identical digits (CIDs). A burst-mode clock-and-data recovery (CDR) using dual gated VCOs (G-VCOs) is designed for 10-Gb/s operation. The relation between the frequency difference of the dual G-VCOs and CID tolerance is derived with a frequency tunable G-VCO circuit. The burst-mode CDR IC is implemented in a 0.13-µm CMOS process. It successfully operates at a data rate of 10.3125 Gb/s. The CDR IC using the edge-detection input amplifier and the G-VCO CDR core achieves amplification and synchronization in 0.2 ns with AC-coupling without a reset signal. The IC also demonstrates 1001 bits of CID tolerance, which is more than enough tolerance for 65-bit CIDs in the 64B/66B code of 10 Gigabit Ethernet. Measured data suggest that dual G-VCOs on a die have over a 20-MHz frequency difference and that the frequency adjusting between the G-VCOs is effective for increasing CID tolerance.