Stabilization of Power Line Impedance for Radiated EMI Level Measurement

Atsuya MAEDA

IEICE TRANSACTIONS on Communications   Vol.E75-B    No.3    pp.148-156
Publication Date: 1992/03/25
Online ISSN: 
Print ISSN: 0916-8516
Type of Manuscript: Special Section PAPER (Special Issue on Measurements and Control of Electromagnetic Interference)
radiated emission testing,  electromagnetic interface,  line impedance stabilization network (LISN),  power line-to-ground impedance,  EMI measurement,  

Full Text: PDF(714.1KB)>>
Buy this Article

It is important to develop methods of measuring radiated electromagnetic interference level that will produce identical results at all measuring locations. We have considered a number of problems which prevent the achievement of identical results, and proposed some solutions. However, agreement of measurement values adequate for practical purposes has not been achieved. After our successive studies, we finally became aware that there is a causal relationship with changes in the line-to-ground impedance of the power supply. It is presumed that power cables of AC-powered devices operate as antenna elements that produce emission. Thus changes in the power line-to-ground impedance cause variations in the radiation efficiency to produce a different EMI level. We therefore made plans to measure the values of line-to-ground impedance at the AC power outlet for the frequency range of 100kHz to 500MHz at various locations where measurements are made of EMI from EUT (Equipment Under Test). The impedance varies greatly between 6ohms and 2 k-ohm, not only according to the frequency, but also according to the measurement location. In such cases, the EMI level shows a different value even with the same EUT, and it usually increases-especially for vertical polarization. We have developed a new type of LISN (Line Impedance Stabilization Network or Artificial Mains Network) to stabilize the power line-to-ground impedance to get consistent measurement conditions. The LISN consists of feed-through capacitors and an disk type RF resistor. The measurements confirm the consistency in the impedance value which is maintained at 50 ohms in the frequency range from 1MHz to 500MHz. Thus the newly developed LISN improves consistency of measurement values at all locations, while it was difficult to obtain good correlation before employing the LISN. We feel confident that incorporation of the method discussed here in the pertinent technical standards of EMI measurements, such as CISPR, would lead to a major improvement in getting consistent measurements values.