A 40-nm 0.5-V 12.9-pJ/Access 8T SRAM Using Low-Energy Disturb Mitigation Scheme

Shusuke YOSHIMOTO  Masaharu TERADA  Shunsuke OKUMURA  Toshikazu SUZUKI  Shinji MIYANO  Hiroshi KAWAGUCHI  Masahiko YOSHIMOTO  

IEICE TRANSACTIONS on Electronics   Vol.E95-C   No.4   pp.572-578
Publication Date: 2012/04/01
Online ISSN: 1745-1353
DOI: 10.1587/transele.E95.C.572
Print ISSN: 0916-8516
Type of Manuscript: Special Section PAPER (Special Section on Solid-State Circuit Design – Architecture, Circuit, Device and Design Methodology)
SRAM,  8T,  low energy,  disturb,  half select,  write back,  

Full Text: PDF(1.9MB)>>
Buy this Article

This paper presents a novel disturb mitigation scheme which achieves low-energy operation for a deep sub-micron 8T SRAM macro. The classic write-back scheme with a dedicated read port overcame both half-select and read-disturb problems. Moreover, it improved the yield, particularly in the low-voltage range. The conventional scheme, however, consumed more power because of charging and discharging all write bitlines in a sub-block. Our proposed scheme reduces the power overhead of the write-back scheme using a floating write bitline technique and a low-swing bitline driver (LSBD). The floating bitline and the LSBD respectively consist of a precharge-less CMOS equalizer (transmission gate) and an nMOS write-back driver. The voltage on the floating write bitline is at an intermediate voltage between the ground and the supply voltage before a write cycle. The write target cells are written by normal CMOS drivers, whereas the write bitlines in half-selected columns are driven by the LSBDs in the write cycle, which suppresses the write bitline voltage to VDD - Vtn and therefore saves the active power in the half-selected columns (where Vtn is a threshold voltage of an nMOS). In addition, the proposed scheme reduces a leakage current from the write bitline because of the floating write bitline. The active leakage is reduced by 33% at the FF corner, 125. The active energy in the write operation is reduced by 37% at the FF corner. In other process corners, more writing power reduction can be expected because it depends on the Vtn in the LSBD. We fabricated a 512-Kb 8T SRAM test chip that operates at a single 0.5-V supply voltage. The test chip with the proposed scheme respectively achieves 1.52-µW/MHz writing energy and 72.8-µW leakage power, which are 59.4% and 26.0% better than those of the conventional write-back scheme. The total energy is 12.9 µW/MHz (12.9 pJ/access) at a supply voltage of 0.5 V and operating frequency of 6.25 MHz in a 50%-read/50%-write operation.